LoginHelp/GuideAbout TracPreferences
WikiTimelineRoadmapBrowse SourceView TicketsNew TicketSearchDownloads

check_lm_sensors

check_lm_sensors is a Nagios plugin to monitor the values of on board sensors and hard disk temperatures on Linux systems

see the INSTALL file for installation instructions

Usage

check_lm_sensors [--help] [--verbose] [--version] [OPTIONS]

Options:

  -?, --help      help

  --check, -c     specifies a check for a sensor

  -l, --low       specifies a check for a sensor value which is too low.
                  Example:
                    --low fan1=2000,1000
                  will give a warning if the value of the fan1 sensor drops
                  below 2000 RPMs and a critical status if it drops below
                  1000 RPMs

  -h, --high      specifies a check for a sensor value which is too high.
                  Example:
                    --high temp1=50,60
                  will give a warning if the value of the temp1 sensor reaches
                  50 degrees and a critical status if it reaches 60 degrees

  -r, --range     specifies a check for a sensor value which should stay
                  in a given range.
                  Example:
                    --range v1=1,2,12
                  will give a warning if the value of the sensor gets outside
                  the 11-13 range (12+-1) and a critical status if the value is
                  outside the 10-14 range (12+-2)

  --rename        renames a sensor in the performance output (useful if you
                  want to have common names for similar sensors across
                  different machines)
                  Example:
                    --rename cputemp=temp1

  --sanitize      sanitize sensor names (e.g., removing spaces)

  --list          list all available sensors

  --nosensors     disable checks on check lm_sensors

  --nodrives      disable checks on drive temperatures

  -d, --drives    enable checks on drive temperature

  --hddtemp_bin   manually specifies the location of the hddtemp binary

  --sensors_bin   manually specified the location of the sensors binary

  -v, --verbose   verbose output

  --version       prints the version and exits

Sensors with a space in the name can be specified
* by escaping the space:                        --high sda\ Temp=50,60
* by quoting the name:                          --high 'sda Temp'=50,60
* by substituting the space with an underscore: --high sda_Temp=50,60
* by using the --sanitize option to remove the space
    --sanitize --high sdaTemp=50,60

Download

Problems and suggestions

 

Wichtiger Hinweis:
Diese Website wird in älteren Versionen von Netscape ohne graphische Elemente dargestellt. Die Funktionalität der Website ist aber trotzdem gewährleistet. Wenn Sie diese Website regelmässig benutzen, empfehlen wir Ihnen, auf Ihrem Computer einen aktuellen Browser zu installieren. Weitere Informationen finden Sie auf
folgender Seite.

Important Note:
The content in this site is accessible to any browser or Internet device, however, some graphics will display correctly only in the newer versions of Netscape. To get the most out of our site we suggest you upgrade to the newer browser.
More information

 
© 2005 ETH Zürich | Imprint | 26.09.2007 | Version 0.12
top